Changing the input display – Integra DTR-7.8 User Manual

Page 49

First Time Setup

—Continued

Notes:

•

For composite video and S-Video upconversion for
the COMPONENT VIDEO MONITOR OUT 1 or
2, the HDMI Monitor setting must be set to No (see
page 45).

signal flow and upconversion.

• This procedure can also be performed on the AV

receiver by using its [Setup], [Enter], and arrow but-
tons.

If you connect an

-capable Onkyo MiniDisc

recorder, CD recorder, or RI Dock to the TAPE IN/OUT
jacks, or connect an RI Dock to the GAME/TV jacks, for

to work properly, you must change this setting.

This setting can only be changed on the AV receiver.

Note:

• DOCK can be selected for the Tape input selector or

Game/TV input selector, but not both at the same time.

Press the [Setup] button.

Setup closes.

Setu

Changing the Input Display

Press the [Tape] or [Game/TV]
input selector button so that
“TAPE” or “GAME/TV” appears
on the display.

Press and hold down the [Tape]
or [Game/TV] input selector but-
ton (about 3 seconds) to change
the setting.

Repeat this step to select MD, CDR, or
DOCK.

For the Tape input selector, the setting
changes in this order:

For the Game/TV input selector, the
setting changes in this order:

GAME/TV

↔

DOCK

1, 2

TAPE

→

CDR

DOCK

→