InFocus DISPLAY LINK IN3902LB - Manual (Page 8)

7
Connecting a computer source
DisplayLink or VGA
If you have a Windows or Macintosh computer, connect the USB cable
between your computer's USB port and the projector's DisplayLink
connector*. Then to begin installation of the DisplayLink software:
Windows: Follow the instructions on the screen.
Macintosh: A folder will open containing a file named DisplayLink
Installer.pkg. Open that file and follow the instructions on the screen.
* For detailed DisplayLink instructions and troubleshooting, and to
download the latest DisplayLink software, go to
www.infocus.com/support/displaylink .
Or, connect one end of the provided computer cable to the VGA 1 or VGA 2
connector on the projector and the other to the VGA connector on your
computer. If you are using a desktop computer, you will need to disconnect
the monitor cable from the computer’s video port first (you can connect this
monitor cable to the Monitor Out connector on the projector, see below).
Connect the black power cord to the Power connector on the side of the
projector and to your electrical outlet. The Power light on the Status
Indicator Panel (on page 18) turns amber.
NOTE
: Always use the power cord that shipped with the projector.
MOLEX
MOLEX
connect USB cable
connect computer cable
connect power cord