Intel SBC-776 - Manual (Page 74)

Chapter 3 Award BIOS Setup 65
Onboard Serial Ports (1, 2)
Normally, the main board’s I/O chips will occupy a certain portion
of memory space. For each I/O device the computer provides an
I/O address. The more devices attached the more address needed
to organize the memory storage areas. If all the I/O devices were
run through the same address, your devices would come to a near
halt. By providing the end user with four serial ports this allows
devices to run more efficiently if needed. Also the corresponding
interrupt needs to be selected.
Selections of logical COM port addresses are as follows. ( 3F8/
IRQ4, 3E8/IRQ4, 2F8/IRQ3, 2E8/IRQ3)
Onboard Parallel Port
Select a logical LPT port address and corresponding interrupt for
the physical parallel port
The Choice: 378/IRQ7, 278/IRQ5, 3BC/IRQ7, disabled
Parallel Port Mode
Two bidirectional parallel ports. Supports SPP, ECP, EPP,
ECP + EPP.
EPP Mode Select
Select the EPP port type 1.7 or 1.9
ECP Mode Use DMA
Select a DMA channel for the port.
PWRON After PWR-Fail
This option will determine how the system will power on after a
power failure.
The choice: off, on , former status