Impex SB 210 - Manual (Page 5)

ASSEMBLY INSTRUCTION
Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen Wrenches
NOTE: It is strongly recommended this machine be assembled by two or more people to
avoid possible injury.
STEP 1 (See Diagram 1)
A.) Slide the Sliding Block (#9) onto the Main Frame (#2) and secure it with a Quick Release
Knob (#13).
B.) Attach the Rear Stabilizer (#8) to the Main Frame (#2). Secure it with two M10 x 5/8” Allen
Bolts (#24) and
∅
¾” Washers (#31).
C.) Attach the Front Stabilizer (#7) to the Front Vertical Frame (#1). Secure it with two M10 x 5/8”
Allen Bolts (#24) and
∅
¾” Washers (#31).
D.) Attach the Main Frame (#2) to the Front Vertical Frame (#1). Secure it with a M10 x 2 7/8”
Allen Bolt (#26), two
∅
¾” Washers (#31), and one M10 Aircraft Nut (#34) to the lower hole.
NOTE: DO NOT over tighten the bolt. The joint needs to swivel in able to fold the bench for
storage. Insert a L-shaped Lock Pin (#15) to the upper hole.
E.) Attach two L-shaped Brackets (#10) to each side of Main Frame. Secure the brackets with two
M10 x 2 ½” Allen Bolts (#25), four Ø ¾” Washers (#31), and two M10 Aircraft Nuts (#34). Do
not tighten the nuts and bolts yet. After installing the seat pad, then come back to this step to
tighten the nuts and bolts.
DIAGRAM 1
4