Image IMBE53910 - Manual (Page 8)

8
7. Press a 38mm Bushing (29) into each side of the
Left Weight Glider (32). Slide the Left Weight
Glider onto the indicated end of the Barbell (35)
and secure it to the Barbell using an M8 x 20mm
Screw (50). Do not tighten the Screw yet. Make
sure the Left Weight Glider is oriented exactly
as shown.
8. Press a 50mm Bushing (47) into the indicated
end of a Weight Adapter (33). Slide the Weight
Adapter onto the Barbell (35) and secure it to the
Barbell using a Large Washer (44) and an M10 x
25mm Bolt (43).
Attach the other Weight Adapter (33) to the other
end of the Barbell (35) in the same manner.
Tighten the M8 x 20mm Screws (50) used in
steps 6 and 7.
7
35
32
29
29
50
9. Note: This step requires the help of a second
person.
Slide the Right Safety Spotter (23) and the Left
Safety Spotter (24) onto the Weight Guides (18).
Make sure the Safety Spotters are oriented
exactly as shown.
Slide the assembled Locking Bar (34) and the
Right and Left Weight Gliders (31, 32) onto the
Weight Guides (18). Make sure the Locking Bar
and Weight Gliders are oriented exactly as
shown.
33
35
47
44
43
8
23
18
18
24
34
31
32
9
10. Press a 60mm Square Inner Cap (55) into each
end of the Top Crossbar (9). Attach the Top
Crossbar to the Uprights (1) using four Joint
Plates (12), eight M10 x 80mm Bolts (41), and
eight M10 Nylon Locknuts (11). Do not tighten
the Nylon Locknuts yet.
Secure the Top Crossbar (9) to the Weight
Guides (18) using two M10 x 30mm Bolts (38)
and two M10 Small Washers (6).
9
38
38
55
55
11
1
1
18
18
41
41
12
12
11
6
6
10