Image IMBE53910 - Manual (Page 13)

13
29. Place the Seat Mounting Bracket (74) on the
Bench Frame (61) so that the Seat Adjustment
Bracket (84) fits over the welded pin on the side
of the Bench Frame.
Lubricate an M10 x 80mm Bolt (41). Attach the
Seat Mounting Bracket (74) to the indicated
bracket on the Bench Frame (61) with the Bolt
and an M10 Nylon Locknut (11). Note: Do not
overtighten the Nylon Locknut; the Seat
Mounting Bracket must pivot easily.
29
61
11
84
74
41
Welded
Pin
Lubricate
28. Press the 20mm x 50mm Inner Cap (82) into the
open end of the Seat Mounting Bracket (74).
Lubricate an M8 x 70mm Bolt (30). Attach the
Seat Adjustment Bracket (84) to the indicated
side of the Seat Mounting Bracket (74) with the
Bolt and an M8 Nylon Locknut (54). Note: Do not
overtighten the Nylon Locknut; the Seat
Adjustment Bracket must pivot easily.
28
82
54
30
74
84
Lubricate
30. Turn the Seat (67) as shown. Attach the wide end
of the Seat to the bracket on the Seat Mounting
Bracket (74) with two M6 x 16mm Screws (89).
Tilt the Seat Mounting Bracket (74) upwards and
attach the narrow end of the Seat (67) to the Seat
Mounting Bracket with an M6 x 35mm Bolt (81)
and an M6 Washer (80).
30
89
81
80
74
67
Bracket
27. Attach the Backrest (68) to the Backrest Tubes
(78) with four M6 x 55mm Screws (90) and four
M6 Washers (80).
27
80
90
68
78