Image IMBE53910 - Manual (Page 10)

10
15. Route the High Cable (13) around another Pulley
(5) and through the indicated slot in the Pulley
Bar (53) as shown. Attach the Pulley inside the
slot using an M10 x 65mm Bolt (56), two M10
Large Washers (58), two Pulley Spacers (15),
and an M10 Nylon Locknut (11). Do not over-
tighten the Nylon Locknut; the Pulley must be
able to turn freely.
16. Route the High Cable (13) up through the Pulley
Bar (53), around another Pulley (5), and back
through the Pulley Bar, as shown. Attach the
Pulley inside the slot in the Pulley Bar using an
M10 x 65mm Bolt (56), two M10 Large Washers
(58), two Pulley Spacers (15), and an M10 Nylon
Locknut (11). Do not overtighten the Nylon
Locknut; the Pulley must be able to turn
freely.
56
58
53
58
11
13
5
15
15
15
16
5
15
56
58
15
11
58 13
53
17. Attach the end of the High Cable (13) to the M10
x 20mm Bolt (26) in the Weight Carriage (22) with
an M10 Nylon Locknut (11).
18. Hold a Pulley (5) inside the High Cable (13) as
shown. Attach the Pulley and a Cable Trap (21) to
the indicated set of holes in the two Pulley Plates
(19) with an M10 x 45mm Bolt (40) and an M10
Nylon Locknut (11). Make sure the Cable Trap
holds the High Cable in the groove of the Pulley.
Do not overtighten the Nylon Locknut; the
Pulley must be able to turn freely.
5
21
40
11
19
13
18
11
22
26
13
17