beautypg.com

Image IMBE53910 User Manual

Page 12

background image

12

23. Press a 50mm Square Outer Cap (73) onto each

end of the Bench Base (62).

Attach the Bench Base Joint Plate (72) to the
Bench Base (62) with two M10 x 70mm Bolts
(91), two M10 Large Washers (58), and two M10
Nylon Locknuts (11).

Attach the Bench Leg (59) to the Bench Base
Joint Plate (72) with two M10 x 70mm Bolts (91),
two M10 Large Washers (58), and two M10 Nylon
Locknuts (11). Be sure the welded nut is in the
position shown.

Do not tighten the M10 Nylon Locknuts (11) yet.

23

91

58

58

91

58

58

59

11

72

73

73

62

Welded Nut

24. Attach the Bench Leg (59) to the Bench Frame

(61) with two Thick Joint Plates (71), four M10 x
70mm Bolts (91), and four M10 Nylon Locknuts
(11).

Note: Tighten all the M10 Nylon Locknuts (11)
used in steps 22–24.

24

59

11

71

61

91

71

25. Press two 25mm x 40mm Inner Caps (79) into

each Backrest Tube (78). Press two 25mm x
40mm Inner Caps into the Backrest Adjustment
Bracket (83).

Lubricate an M10 x 190mm Bolt (75). Attach the
Backrest Tubes (78) to the welded tube on the
Backrest Adjustment Bracket (83) with the Bolt,
two M10 Large Washers (58), and an M10 Nylon
Locknut (11). Make sure that the Backrest
Tubes are turned as shown. The indicated
holes are not centered in the Backrest Tubes.
Turn the Backrest Tubes so the holes are clos-
er to the floor. Do not overtighten the Nylon
Locknut; the Backrest Tubes must pivot easily.

25

79

11

83

Lubricate

Holes

Welded

Tube

79

79

75

58

58

78

26. Lubricate an M10 x 190mm Bolt (75). Attach the

Backrest Tubes (78) to the welded tube on the
Bench Frame (61) with the Bolt, two M10 Large
Washers (58), and an M10 Nylon Locknut (11).
Note: Do not overtighten the Nylon Locknut;
the Backrest Tubes must pivot easily.

26

78

11

61

75

58

58

Lubricate

Welded Tube