Image IMBE53910 - Manual (Page 7)

7
3. Attach an Upright (1) to each Base (7) using two
Joint Plates (12), four M10 x 80mm Bolts (41),
and four M10 Nylon Locknuts (11). Make sure the
Uprights are oriented exactly as shown. Do not
tighten the Nylon Locknuts yet.
3
1
1
41
12
12
7
7
12
12
11
41
4. Insert a Weight Guide (18) into the indicated hole
in each Base (7). Attach the Weight Guides to the
Bases using two M10 x 75mm Bolts (39), four
M10 Small Washers (6), and two M10 Nylon
Locknuts (11). Do not tighten the Nylon
Locknuts yet.
5. Press a 25mm Bushing (48) into each end of the
Locking Bar (34). Slide the Barbell (35) into the
Locking Bar.
4
18
18
39
39
6
11
7
7
11
6
6
6
5
34
35
48
48
6
35
29
29
31
50
6. Press a 38mm Bushing (29) into each side of the
Right Weight Glider (31). Slide the Right Weight
Glider onto the indicated end of the Barbell (35)
and attach it to the Barbell using an M8 x 20mm
Screw (50). Do not tighten the Screw yet. Make
sure the Right Weight Glider is oriented exact-
ly as shown.