Intel System Board G4H875-B - Manual (Page 56)

56
2
Hardware Installation
Chassis Open Connector
2
1
Ground
Chassis signal W
The system board supports the chassis intrusion detection func-
tion. To use this function, connect the chassis intrusion sensor
cable from the chassis to J6. Whenever a chassis component has
been removed, the sensor sends signal to J6 alerting you of a
chassis intrusion event. To disable this function, refer to the “Intrusion
Event” section on page 95 of the manual.
Note:
The Hardware Doctor utility does not support the chassis
intrustion detection function. This function must be configured in
the BIOS. Refer to page 95 for more information.