Impex MWM-7300 - Manual (Page 11)

STEP 3 (See Diagram 3)
A.) Do not tighten Nuts and Bolts until instructed to do so.
B.) Attach the Lower Cross Brace (#16) to the Weight Stack Frame (#17). Secure them with two
M10 x 3 1/8” Carriage Bolts (#72), one 5 1/8” x 1 5/8” Bracket (#58), two Ø ¾” Washers (#91),
and two M10 Aircraft Nuts (#94).
C.) Attach the Upper Cross Brace (#15) to the Rear Vertical Frame (#3) and Upper Frame (#4).
Secure them together with two M10 x 4” Carriage Bolts (#71), two Ø ¾” Washers (#91), and
two M10 Aircraft Nuts (#94).
D.) Secure the other end of Upper Cross Brace to Weight Stack Frame with two M10 x 4”
Carriage Bolts (#71), two Ø ¾” Washers (#91), and two M10 Aircraft Nuts (#94).
E.) Securely tighten all Nuts and Bolts installed in this step and Step-1.
F.) Attach the Leg Press Frame (#8) to the Main Base Frame (#1). Secure it with M10 x 7 5/8”
Allen Bolt (#75), two Ø ¾” Washers (#91), and one M10 Aircraft Nut 9#94). Do not over
tighten the Nut and Bolt. Make sure the Leg Press Frame is adjustable.
G.) Insert a 7 ½” Leg Press Lock Pin (#31) through the holes on Leg Press Frame and the post
on Main Base Frame to hold the Leg Press Frame at desired position.
H.) Attach the Front Press Base (#5) to the Upper Frame. Secure it with one 6 5/8” (#56), two Ø
¾” Washers (#91), and two M10 Aircraft Nuts (#94). Do not over tighten the Nuts. Make
sure the Front Press is able to swivel smoothly.
10