Section 13—transporting, Transporting the scooter, Disassembling – Invacare HMV Highly 300 User Manual
Page 60: Assembling
SECTION 13—TRANSPORTING
60
SECTION 13—TRANSPORTING
ƽ WARNING
After ANY adjustments, repair or service and BEFORE use, make sure that all
attaching hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service, turn power OFF and
remove key from ignition.
TRANSPORTING THE SCOOTER
NOTE: For this procedure, refer to FIGURE 13.1.
300
DISASSEMBLING
1. If installed on scooter, remove the front basket. Refer to Removing/Installing the Front
2. Remove the seat. Refer to Removing/Installing the Seat on page 34.
3. Remove the rear shroud. Refer to Removing/Installing the Rear Shroud on page 44.
4. Remove the batteries. Refer to Removing/Installing the Batteries on 300 on page 50.
5. Fold tiller down to lowest locked position. Refer to Adjusting the Tiller Angle on
ASSEMBLING
1. Unfold tiller. Refer to Adjusting the Tiller Angle on page 43.
2. Install the batteries. Refer to Removing/Installing the Batteries on 300 on page 50.
3. Install the rear shroud. Refer to Removing/Installing the Rear Shroud on page 44.
4. Install the seat. Refer to Removing/Installing the Seat on page 34.
5. If desired, install the front basket. Refer to Removing/Installing the Front Basket on