IBM LA75P - Manual (Page 22)

Many programs give you two ways to change these settings:
You can change the settings in each individual file you print.
You can change the program’s default settings so that every time you use
the program, these new settings are in effect.
3.2 Using the Sheet Feeder
After stacking paper in the sheet feeder, make sure that the Ready indicator
(RDY) on the printer’s control panel is lit up, indicating that the printer is
on-line and ready to print. When the printer is on-line, and receives print
data from the computer, the first sheet is loaded automatically. Subsequent
sheets are then loaded as necessary. When the paper bin is empty, the printer
automatically goes off line, and the Ready indicator (RDY) begins to blink. To
resume printing, stack more paper in the sheet feeder, press the Ready switch,
and then the Form Feed (FF) switch.
Caution: If you turn off the printer when the printer detects a paper out or
paper jam condition, any data remaining in the printer’s buffer is lost.
Note: If you have installed the sheet feeder with the power ON, switch the
power OFF, then ON again, for the sheet feeder to be automatically selected by
the printer’s firmware.
3.3 Removing the Sheet Feeder
To remove the Automatic Sheet Feeder, carry out the following steps:
1 Feed through any paper that may be wrapped around the platen (black
roller) by pressing the FF switch.
2 Turn the printer OFF.
3 Remove the sheet feeder’s rear cover.
4 Remove the printer’s access cover.
5 Detach the sheet feeder from the printer.
6 Replace the sheet feeder’s rear cover.
7 Replace the printer’s paper cover.
8 Replace the insert to the printer’s access cover.
9 Replace the printer’s access cover.
10 Turn the printer ON.
3–2 Operating and Removing the Sheet Feeder