Insignia NS-LCD37HD-09 - Manual (Page 7)

5
Insignia NS-LCD37HD-09 37" LCD TV
www.insignia-products.com
Note to CATV system installer
This reminder is provided to call the CATV
system installer’s attention to Article 820-40 of
the NEC that provides guidelines for correct
grounding and in particular, specifies that the
cable ground must be connected to the
grounding system of the building as close to the
point of cable entry as practical.
Features
Front
Right side buttons
Right side jacks
# Component Description
1 Power indicator Lights blue when your TV is turned
on. Lights red when your TV is in
standby mode.
2 Remote control
sensor Receives signals from the remote
control. Do not block.
# Button Description
1 CH /CH Press to go to the next or previous channel
in the channel list.
2 VOL /VOL Press to increase or decrease the volume.
3 MENU Press to open the on-screen menu.
4 INPUT Press to select the video input. For more
information, see “Selecting the video input
source” on page 11.
5
(power)
Press to turn your TV on or off. When you
turn off your TV, it goes into standby mode.
# Jack Description
1 HDMI 3 Connect an HDMI device to this
jack.
2 HDMI 1/HDMI 2 Connect HDMI devices to this jack.
3 VGA PIC/AUDIO Connect a computer to these jacks.
4 COMPONENT IN1
COMPONENT IN 2 Connect component video devices
to these jacks.
5 S-VIDEO/AV1
INPUT Connect an S-Video or AV device to
one of these video jacks, then
connect the audio to the adjacent
audio jacks.
6 AV OUT Connect a VCR for recording to
these jacks.
7 RF Connect an antenna or cable TV to
this jack.
8 RS-232 For service only. Do not use.
9 S/PDIF OUT Connect to a digital audio system.