Impex MP-3105 - Manual (Page 12)

STEP 3 (See Diagram 3)
A.) Place the Weight Glide Post (#12) onto the Weight Glide Post Base (#11). Secure it
with four M10 x ¾” Carriage Bolts (#79), Ø ¾” Washers (#87) and M10 Aircraft Nuts
(#89).
B.) Slide the Sliding Weight Post (#22) onto the Weight Glide Post.
C.) Attach the Upper Frame (#13) onto the Rear Vertical Beam (#10). Secure it with two
M10 x 3 1/8” Carriage Bolts (#84), one 3 ½” x 1 5/8” Bent Bracket (#28), two Ø ¾”
Washers (#87), and two M10 Aircraft Nuts (#89).
D.) Attach the rear of Upper Frame (#13) to the Weight Glide Post (#12) and secure it with
one 2 ¾” x 1 ¾” Bracket (#29), M10 x 2 3/8” Allen Bolt (#75) and Ø ¾” Washer (#87) to
the upper hole. Secure the lower hole with one M10 x 2 ½” Carriage Bolt (#82), Ø ¾”
Washer (#87), and M10 Aircraft Nut (#89).
E.) Attach one Upper Frame Support (#16) to the Left Vertical Beam (#1). Secure it with
one 2 ¾” x 2” Bent Bracket (#27), M10 x 3 3/8” Allen Bolt (#78) and Ø ¾” Washer (#87)
to the upper hole. Secure the lower hole with one M10 x 3 ½” Carriage Bolt (#85), Ø ¾”
Washer (#87), and M10 Aircraft Nut (#89). Repeat the same step to install the other
Upper Frame Support (#16) to the Right Vertical Beam (#2).
F.) Attach the two Upper Frame Supports (#16) to the Upper Frame (#13) from each side.
Secure them together with two M10 x 2 3/8” Carriage Bolts (#81), Ø ¾” Washers (#87),
and M10 Aircraft Nuts (#89).
G.) Securely tighten all Nuts and Bolts previously installed.
11