Integra DPS-7.3 - Manual (Page 61)

61
Operating Components not Reached by the
Remote Controller Signals (IR IN/OUT)
The following equipment (sold separately) is essential for
operation:
• Integra/Onkyo’s Multi-Room System kits (IR Remote Controller
Extension System), or
• Multiroom A/V distribution and control systems from Niles ® and
Xantech ® to name a few.
If the remote controller signal does not
reach the DPS-7.3 remote sensor
If the DPS-7.3 is located inside a cabinet or other
enclosure where the infrared rays from the remote
controller cannot enter, then operation with the remote
controller will not be possible. In such a case, it will be
necessary to install a remote sensor at a location
outside of the cabinet for the infrared rays from the
controller to reach.
If the remote controller signal does not
reach other components
In this situation, you will need to use a commercially
available IR emitter. Connect the mini plug of the IR
emitter to the IR OUT terminal on the DPS-7.3 and then
place the IR emitter on the remote sensor of the
component or facing it. When the IR emitter is
connected, only the signal input to the IR IN terminal is
output to the IR OUT terminal. The signal input from the
remote sensor on the front of the DPS-7.3 will not be
output to the IR OUT terminal.
Make connection as shown below. Do not plug the
equipment into the power source until the connection is
completed.
OUT
IN
IR
OUT
IN
IR
IR Receiver
Remote Controller
DPS-7.3
IR IN
Connecting
block
In the
cabinet
Mini plug cable
from connecting block
:Signal flow
DPS-7.3
IR Emitter
DPS-7.3
IR IN
Connecting
block
IR Receiver
Remote Controller
:Signal flow
otther
component
IR OUT
otther component
:Signal flow
Remote control
sensor
Emitter
Mini plug cable
IR Emitter
Mini plug
DPS-7.3