InFocus 560 - Manual (Page 52)

Maintenance
44 LitePro 560/570 User’s Guide
4. Locate the fuse holder on the side of the LitePro between the
power switch and the power cord connector as shown below.
5. Using a small coin or a flat blade screwdriver, turn the fuse
holder a quarter turn in the clockwise direction.
6. Pull the fuse holder out of the LitePro as shown in Figure 23.
7. Remove the blown fuse from the fuse holder.
8. Push the new fuse into the clips of the holder until it is securely
seated as shown in Figure 24.
9. Place the fuse holder back in the LitePro.
10. Using the same tool you used in step 5, turn the fuse holder a
quarter turn counter-clockwise.
11. Plug the power cord back in.
12. Press the “|” side of the power switch to turn the LitePro
back on.
Figure 22. Locating the Fuse
fuse
MAINT.FRA Page 44 Tuesday, January 28, 1997 9:57 AM