InFocus 560 - Manual (Page 40)

Using the LitePro
32 LitePro 560/570 User’s Guide
Prog Button
Use the Prog Button function to assign an operation to the remote’s
prog button. You can assign any one of these functions.
• Clear Black and Clear White make the entire screen black or white,
respectively. Press any key to return to your image.)
• LP 560LS & LP 570LS: LS Grab captures the current image and
saves it on your LiteShow disk. Refer to your LiteShow User’s
Guide for more information.
• LP 570 & LP 570LS: Mic turns the microphone off or on.
• LP 570 & LP 570LS: Loudness turns Loudness on or off. Loudness
adjusts the audio quality by enhancing the bass portion of the
sound.
• RS-232 enables Remote Control Programmer if it is installed on
your computer. Remote Control Programmer allows you to use
the arrow buttons on the LitePro remote to control your com-
puter. You will also need to connect your serial source to the
“SERIAL” connector on the LitePro. Refer to the Remote Control
Programmer User’s Guide for more information. (When RS-232 is
enabled, you cannot use the arrow buttons to select menu func-
tions.)
• Sync adjusts the signal synchronization between the LitePro and
the computer.
• Palette changes the number of displayable colors in the projected
image. Refer to page 31 for more information about the Palette
settings.
• LP 570 & LP 570LS: Mute turns off the sound.
• Text Mode switches the display to Text Mode. Text Mode is
needed only if you are displaying DOS text that is 720 pixels
wide. Refer to page 34 for more information.
To change the prog button assignment:
1. Press the menu button to display Menu 1.
2. Use the right or left arrow buttons to highlight “Menu 2”
3. Press select/enter to display Menu 2.
4. Use the right or left arrow buttons to highlight “Prog Button”.
5. Press select/enter until the function you want is displayed. Now,
whenever you press prog , the LitePro performs the function you
selected.
USING.FRA Page 32 Tuesday, January 28, 1997 9:55 AM