English – Intel GA-8I915MK-GV User Manual
Page 43
BIOS Setup
- 43 -
English
CPU Host Clock Control
Please note that if your system is overclocked and cannot restart, please wait 20secs.
for automatic system restart or clear the CMOS setup data and perform a safe restart.
Disabled
Disable CPU Host Clock Control. (Default value)
Enabled
Enable CPU Host Clock Control.
CPU Host Frequency (Mhz)
100MHz ~ 600MHz
Set CPU Host Frequency from 100MHz to 600MHz.
If you use FSB533 Pentium 4 processor, please set "CPU Host Frequency" to 133MHz.If you use
FSB800 Pentium 4 processor, please set "CPU Host Frequency" to 200MHz.
Incorrect using it may cause your system broken. For power End-User use only!
PCI-E Frequency to CPU
Auto
Set PCI Express frequency to synchronize/asychronize with CPU according to
different condition. (Default value)
ASYC
Fix PCI Express frequency to 100MHz.
Memory Frequency For
Wrong frequency may make system can't boot, clear CMOS to overcome wrong frequency issue.
for FSB(Front Side Bus) frequency=533MHz,
2.5
Memory Frequency = Host clock X 2.5
3
Memory Frequency = Host clock X 3.
4
Memory Frequency = Host clock X 4.
Auto
Set Memory frequency by DRAM SPD data. (Default value)
for FSB(Front Side Bus) frequency=800MHz,
1.66
Memory Frequency = Host clock X 1.66.
2.0
Memory Frequency = Host clock X 2.0.
2.66
Memory Frequency = Host clock X 2.66.
Auto
Set Memory frequency by DRAM SPD data. (Default value)
Memory Frequency (Mhz)
The values depend on "Memory Frequency For" item.
DIMM OverVoltage Control
Please note that by overclocking your system through the increase of the DIMM voltage, damage
to the memory may occur.
Normal
Set DIMM OverVoltage Control to Normal. (Default value)
+0.1V
Set DIMM OverVoltage Control to +0.1V.
+0.2V
Set DIMM OverVoltage Control to +0.2V.
+0.3V
Set DIMM OverVoltage Control to +0.3V.
Incorrect using it may cause your system broken. For power End-User use only!
PCI-E OverVoltage Control
Normal
Set PCI-E OverVoltrage Control to Normal. (Default value)
+0.1V
Set PCI-E OverVoltrage Control to +0.1V.
+0.2V
Set PCI-E OverVoltrage Control to +0.2V.
+0.3V
Set PCI-E OverVoltrage Control to +0.3V.
Incorrect using it may cause your system broken. For power End-User use only!