Integra DTR-5.3 - Manual (Page 7)

7
Using the remote controller
Point the remote controller toward the remote control sensor. The
STANDBY indicator lights up when the unit receives a signal from
the remote controller.
Notes:
• Make sure that the remote control sensor is not subject to strong
light such as direct sunlight or inverted fluorescent light for it
may prevent proper operation of the remote controller.
• Using another remote controller in the same room or using the
DTR-6.3/5.3 near equipment that uses infrared rays may cause
operational interference.
• Do not put objects on the remote controller. Its buttons may be
pressed by mistake and drain the batteries.
• Make sure the audio rack doors do not have colored glass.
Placing the DTR-6.3/5.3 behind such doors may prevent proper
remote controller operation.
• If there is any obstacle between the remote controller and the
remote control sensor, the remote controller will not operate.
Installing the remote controller batteries
1. Remove the battery compartment cover by pressing it
and sliding it in the direction shown by the arrow
below.
2. Insert two AA (R6 or UM-3) batteries into the battery
compartment. Carefully follow the polarity diagram
(positive (+) and negative (–) symbols) inside the
battery compartment.
3. After the batteries are installed and seated correctly,
replace the compartment cover.
Notes:
• Do not mix new batteries with old batteries or different kinds of batteries.
• To avoid corrosion, remove the batteries if the remote controller
will not be used for a long time.
• Remove dead batteries immediately to avoid damage from corrosion.
If the remote controller does not operate smoothly, remove the old
batteries and replace them both with two new AA batteries.
Before using this unit
Supplied accessories
Check that the following accessories are supplied with the DTR-6.3/5.3.
AM loop antenna × 1
Remote controller (RC-481M) × 1
Batteries (AA, R6 or UM-3) × 2
FM indoor antenna × 1
3 2 1
30˚
30˚
Remote control sensor
STANDBY indicator
DTR-6.3/5.3
Approx. 16 feet
(5 meters)
Speaker cable label × 1
Fr ont Left Fr ont Left
SP-B
/ Zone 2 Left
SP-B
/ Zone 2 Left
Surr
o und Right
Surr
o und Right
Surr ound Bac
k
Right
Surr ound Bac
k
Right Zone 2 Right Zone 2 Right
Fr ont Left Fr ont Left SP-B
/ Zone 2
Left SP-B
/ Zone 2
Left
Fr ont Right Fr ont Right
SP-B
/ Zone 2 Right
SP-B
/ Zone 2 Right
Fr ont Right Fr ont Right SP-B
/ Zone 2
Right SP-B
/ Zone 2
Right Surr
o und
Right Surr
ound
Right
Center Center
Center Center
Surr
o und Left
Surr
o und Left
Surr
o und
Left Surr
ound
Left Surr ound Bac
k
Right Surr o und Bac
k
Right Zone 2 Right Zone 2 Right
Surr ound Bac
k Left
Surr ound Bac
k Left Zone 2 Left Zone 2 Left
Surr ound Bac
k
Left Surr o und Bac
k
Left Zone 2 Left Zone 2 Left
1 2
3
Speaker Cable
Power cord × 1
Protective caps
For digital jack × 1
For analog jack × 1
Protective caps for the Video4 jacks
on the front of the DTR-6.3/5.3. Be
sure to always attach the protective
caps when you are not connecting a
device to the VIDEO 4 jacks.