Integra DTR-5.3 - Manual (Page 22)

22
When using the ZONE 2 PRE OUT terminals
If you are using a 5.1-channel speaker system in the main room, you
can connect the amplifier for the remote zone (Zone 2) to the open
ZONE 2 PRE OUT terminals and connect the remote zone speakers.
When using the ZONE 2 OUT terminals
The ZONE 2 OUT terminal is a constant output. Connect to the
LINE input of the amplifier (CD, tape, etc.). Adjust the volume with
the amplifier connected to the ZONE 2 LINE OUT terminal.
1. Connect the DTR-6.3 to the amplifier for the remote zone.
2. Connect the remote zone speaker cables to the
speaker terminals on the amplifier.
Adjust the volume level at the amplifier.
Note:
The ZONE 2 OUT terminals of the DTR-6.3 are of a fixed output level.
Connecting the remote zone (Zone 2) speakers
(DTR-6.3 only)
The DTR-6.3 allows you to listen to two separate input sources at the
same time. This allows you to, for example, place speakers in two
different rooms so that two or more people can enjoy two different
kinds of music at the same time. The room where the DTR-6.3 is
actually located is referred to as the main room while the separate
room is referred to as the remote zone (Zone 2). In addition, the IR
IN terminal of the DTR-6.3 allows you to control the DTR-6.3 from
the remote zone (Zone 2) with the remote controller even though the
remote zone is physically separated. The diagram below shows how
to make the proper connections for the remote zone.
When using the ZONE 2 SPEAKERS terminals
If you are using a 5.1-channel speaker system in the main room, you
can connect the speakers for the remote zone (Zone 2) to the open
ZONE 2 SPEAKERS terminals.
Note:
It is important to be aware of the speaker impedance (see page 32).
ZONE 2
SPEAKERS
R
L
Remote Zone (Zone 2) Main Room
Zone 2
Right
speaker
Zone 2
Left
speaker
FRONT SURROUND CENTER ZONE 2
SURROUND
BACK
R
L
R
L
PRE OUT
Remote Zone (Zone 2) Main Room
Zone 2
Right
speaker
Zone 2
Left
speaker
Power amplifier
Left (white)
Right (red)
DTR-6.3
DTR-6.3
L R
PHONO IN
DC IN
24V 1A
RS232
L
R
ZONE 2
LINE OUT
L R
PHONO IN M
ZONE 2
OUT
DC IN
24V 1A
RS232
L
R
ZONE 2
LINE OUT
Remote Zone (Zone 2)
Main Room
Zone 2
Right
speaker
Zone 2
Left
speaker
Zone 2 amplifier
Left (white)
Right (red) DTR-6.3