Integra DTR-5.3 - Manual (Page 30)

30
Make the connections as shown below. Do not plug in any
equipment to the power outlet until all the connections are complete.
If the remote controller signal does not reach
other components
In this situation, you will need to use a commercially available IR
emitter. Connect the mini plug of the IR emitter to the IR OUT
terminal on the DTR-6.3/5.3 and then place the IR emitter on the
remote sensor of the component or facing it. When the IR emitter is
connected, only the signal input to the IR IN terminal is output to the
IR OUT terminal. The signal input from the remote sensor on the
front of the DTR-6.3/5.3 will not be output to the IR OUT terminal.
In order to use the remote controller to control the DTR-6.3/5.3
from a remote location, you will need to prepare a multi-room
kit (sold separately) such as one of those given below:
• Onkyo’s Multi-Room System kit (IR Remote Controller
Extension System)
• Multiroom A/V distribution and control system such as those
from Niles ® and Xantech ®
If the remote controller signal does not reach the
DTR-6.3/5.3 remote sensor
If the DTR-6.3/5.3 is located inside a cabinet or other enclosure
where the infrared rays from the remote controller cannot enter, then
operation with the remote controller will not be possible. In such a
case, it will be necessary to install a remote sensor at a location
outside of the cabinet where the infrared rays from the controller can
reach.
DTR-6.3 only:
With this connection, select “Main” at “Preference”
→ “IR IN
Position” (see page 56).
DTR-6.3 only:
The IR IN input allows you to control the DTR-6.3 from the remote
zone (Zone 2) with the remote controller even though the remote
zone may be on the other side of the building from the main zone.
The diagram below shows how to make the proper connections for
the remote zone.
With this connection, select “Zone 2” at “Preference”
→ “IR IN
Position” (see page 56).
Operating components not reached by the remote
controller signals (IR IN)
(DTR-6.3/5.3)
From connecting block
Connecting
block
DTR-6.3
Main room
: Signal flow
To IR IN
Zone 2 room
IR Receiver
Remote controller
IR IN
DTR-6.3/5.3
In the
cabinet
Remote Controller
Connecting
block
IR Receiver
: Signal flow
REMOTE
CONTROL
IN
OUT
IR
Mini plug cable
DTR-6.3
IR IN
IR OUT
Connecting
block
IR Receiver
DTR-6.3/5.3
IR Emitter
Remote Controller
other
component
: Signal flow
REMOTE
CONTROL
IN
OUT
IR
Remote control
sensor
other component
Emitter
Mini plug cable
: Signal flow
Mini plug
IR Emitter
DTR-6.3/5.3