Memorex MLT1912 - Manual (Page 17)

16
SETTING THE MENU (CONTINUED)
Press the STANDBY button 1 to turn on the TV; the
STANDBY indicator will turn off. Press the SOURCE button
2
to select TV (NTSC) or ATSC. Press the MENU button 3;
the Main Menu screen will appear.
NOTE: To receive an ATSC signal, press the SOURCE
button 2 repeatedly to select ATSC mode or select TV
mode for NTSC signal.
3
1
2
Select Setup using the CHANNEL/Navigation UP 1 or
DOWN 2 button, then press the VOLUME UP/Navigation
Right button 3 to select it. Select Preset using the
CHANNEL/Navigation UP 1 or DOWN 2 button, then
press the VOLUME UP/Navigation Right button 3 to
select it.
3
1
2
Select Reception using the CHANNEL/Navigation UP 1 or
DOWN 2 button, then press the VOLUME UP/Navigation
Right button 3 to select it. Select TV (when using VHF/UHF
antenna) or CATV (when using Cable TV) using the
CHANNEL/Navigation UP 1 or DOWN 2 button, then
press the VOLUME UP/Navigation Right button 3 to
select it.
3
1
2
3
Press the MENU button repeatedly when finished or wait
approx. 10 seconds to exit the menus.
4
2 1
SELECTING THE RECEPTION (TV/CATV)
NOTE:
• If no buttons are pressed for approx. 10 seconds, the menu will disappear automatically.