Vcr connections (continued), Dvd connections – Memorex MLT1912 User Manual
Page 12
11
CONNECTION USING S-VIDEO CABLE:
Follow the instructions below to connect an S-VIDEO VCR to your television using an S-video cable.
(CABLES NOT INCLUDED.)
VCR CONNECTIONS (CONTINUED)
1. Connect the cable, satellite or incoming
antenna to the ANT jack on the rear of
the VCR.
2. Connect the left and right audio cable from
the VCR’s AUDIO OUT jacks to the TV’s
left and right AUDIO IN jacks.
3. Connect the VCR’s S-VIDEO OUT jack to
the TV’s S-VIDEO IN jack.
4. Press the SOURCE button until S-VIDEO
appears on the TV screen and press PLAY
on the VCR to watch a tape.
NOTE: Side panel is accessible by pressing in
on the tabs, then lift the side cover off. After
connections have been made, slide the wires
through the bottom opening of the cover and
replace cover.
DVD CONNECTIONS
CONNECTION USING AUDIO/VIDEO CABLES:
Follow the instructions below to connect a DVD player to your television using Audio/Video cables.
(CABLES NOT INCLUDED.)
1. Connect the left and right audio cable from
the DVD’s AUDIO OUT jacks to the TV’s
left and right AUDIO IN jacks. Connect the
DVD’s VIDEO OUT jack to the TV’s VIDEO
IN jack.
2. Press the SOURCE button until AV
appears on the TV screen and press PLAY
on the DVD to watch a DVD.
NOTE: Side panel is accessible by pressing in
on the tabs, then lift the side cover off. After
connections have been made, slide the wires
through the bottom opening of the cover and
replace cover.
Jack panel is shown
on its side. Top of
panel is this side.
Jack panel is shown
on its side. Top of
panel is this side.