Miller Electric DS-2 - Manual (Page 15)

OM-197 509 Page 11
3-11. Installing Wire Spool And Adjusting Hub Tension
Ref. ST-802 483-A / Ref. ST-072 573-B
When a slight force is needed
to turn spool, tension is set.
15/16 in
Tools Needed:
1 Hub Support Arm
2 Spool Hub
3 Retaining Ring
4 Hub Pin
Remove retaining ring. Slide wire
spool onto spool hub so wire feeds
off bottom of spool . Install spool so
hub pin fits spool hole. Reinstall re-
taining ring.
5 Tension Nut
Adjust tension nut so a slight force
is needed to turn spool.
1
2
3
5
2
4