Miller Electric DS-2 - Manual (Page 14)

OM-197 509 Page 10
1 Gun Securing Knob
Loosen knob.
2 Gun Block
3 Gun End
Slide gun end as far as possible
into gun block and tighten gun se-
curing knob.
4 Gun Trigger Plug
Connect gun trigger plug to match-
ing receptacle on wire feeder.
3-9. Connecting Welding Gun
Ref. ST-802 483-A
1
2
3
4
1 Pendant
2 Nameplates
Pendant has three nameplates
stacked one on top of the other.
Each nameplate contains the volt-
age and amperage ranges for a dif-
ferent size flux cored welding wire
(for reference only).
Unit is shipped with 1.2 mm wire
nameplate on top. To change to 1.4
mm or 1.6 mm wire nameplate, re-
move the four screws and bring the
desired nameplate to the front.
Install the four (4) screws back in
place to hold the nameplates.
3-10. Changing Nameplates
Ref. ST-802 483-A
1
2
Tools Needed:
5/16 in