Motorola CP150TM - Manual (Page 161)

6880309N62-C June, 2005
465-495 MHz UHF Theory Of Operation: UHF Transmitter 10-3
10.3 UHF Transmitter
The UHF transmitter covers the range of 465-495 MHz. Depending on model, the output power of the
transmitter is either switchable on a per-channel basis between high power (4 watts) and low power
(1 watt), or is factory preset to 2 watts. The transmitter is divided into four major blocks as shown in
Figure 10-2 .
• Power Amplifier
• Harmonic Filter
• Antenna Matching Network
• Power Control.
Figure 10-2. UHF Transmitter Block Diagram
10.3.1 Transmitter Power Amplifier
The transmitter power amplifier has three stages of amplification. The first stage, Q100, operates in
Class A from the 5T source. It provides 17 dB of gain and an output of 50 mW. The current drain is
typically 30mA. Components C105 and L103 match the output of Q100 to the 50
Ω input of the module
U110.
U110 is a two stage Silicon MOS FET power amplifier module. Drain voltage is obtained from UNSW
B+ after being routed through current-sense resistor R150 in the power control circuit. The output
power of the module is controlled by varying the DC gate bias on U110 pin 2 (VGG).
10.3.2 Antenna Switch
The antenna switch consists of two pin diodes, D120 and D121. In the receive mode, both diodes are
off. Signals applied at the antenna or at jack J140 are routed, via the harmonic filter, through network
C122-C124 and L121, to the receiver input. In the transmit mode, Q170 is on and TXB+ is present,
forward-biasing both diodes into conduction. The diode current is 20 mA, set by R120-R121. The
transmitter RF from U110 is routed through D120, and via the harmonic filter to the antenna jack.
D121 conducts, shunting RF power and preventing it from reaching the receiver. L121 is selected to
appear as a 1/4 wave at UHF, so that the low impedance of D121 appears as a high impedance at the
junction of D120 and the harmonic filter input. This provides a high series impedance and low shunt
impedance divider between the power amplifier output and receiver input.
10.3.3 Harmonic Filter
The harmonic filter consists of components C130-C136 and L130-L132. The harmonic filter is a
seven-pole Chebychev low-pass configuration, optimized for low insertion loss, with a 3 dB frequency
of approximately 655 MHz and typically less than 0.8 dB insertion loss in the passband.
Power Control
Harmonic Filter
Antenna
Matching
Network
Power Amplifier Module U110 Q100
TX_INJ
(From VCO)
5T
VDD VGG
TX_ENA
PWR_SET
USWB+
RX_IN
(To Receiver)
Antenna
Switch
J140 Antenna
Jack
Antenna