Getting started – Siemens Xelibri 6 User Manual

Page 4

Getting Started

right page (3)

of TWIGGY e2, A31008-H9240-A45-2-7619 (26.09.2003, 07:36)

RI Vers

. 2\UGS\TWIGGY\e2\twiggy_getting_started.fm

VAR Language: ENG; VAR issu

e date: 18-September-2003

Getting
Started

Fitting battery

Gently press in the left end of
door (1) and slide it open (2)
to reveal SIM slot and charger
socket.
Continue to slide door to left
until keypad disengages –
maybe use a fingernail to lift
it (3).
The battery fits on the under-
side of the keypad. Gently flip
keypad into the lid (4).
Engage the battery tabs in the
slots (5), then swing battery
into place (6).
Click the keypad back into
place.
To remove battery, gently
press the end of the retaining
clip (7) towards it.

Fitting SIM card

Your service provider supplies your
SIM card. If it’s credit card size,
snap out the smaller portion and
tidy any rough edges.
Open SIM door (Fitting battery,
above) and insert SIM in the top
slot, positioning the cut-off corner
as shown. Press until it clicks into
place.
The SIM is spring-loaded – to remove, press it in.

Charging

Open the SIM door (Fitting bat-
tery, above).
Insert the supplied charger into an
easily accessible mains socket of
the correct rating and plug into the
bottom socket with the pins face
up. While it charges, the battery

indicator will animate – if it doesn’t, then see What if...?
on p 21. Allow 2-3 hours for a full charge.
Be sure to unplug the charger from the mains when
you’re finished.

twiggy.book Seite 3 Dienstag, 30. September 2003 4:52 16