English – Metabo TDP 7500 S User Manual
Page 11
11
ENGLISH
Ensure there is a sufficient water
supply.
Make sure the float switch can
move unrestricted.
Motor hums but does not start:
x
Pump blocked by foreign object.
Clean pump.
Pump does not pump properly:
x
Delivery head too high.
Observe max. delivery head (see
"Technical Specifications").
x
Discharge hose kinked.
Straighten discharge hose.
x
Discharge hose leaky.
Seal discharge hose, tighten
screw fittings.
Pump runs very noisy:
x
Pump primes air.
Ensure there is a sufficient water
supply.
Adjust float switch correctly.
Hold pump at an angle when sub-
merging.
Pump runs continuously:
x
Float switch does not reach lower
position.
Make sure the float switch can
move unrestricted.
A
Danger!
Repairs to electric tools must
only be carried out by a qualified
electrician!
Electric tools in need of repair can be
sent to an authorised service center in
your country. See spare parts list for
address.
Please attach a description of the fault to
the electric tool.
The packaging of the pump can be
100 % recycled.
Worn out power tools and accessories
contain considerable amounts of valua-
ble raw and plastic materials, which can
be recycled.
These instructions are printed on chlo-
rine-free bleached paper.
9.
Repairs
10. Environmental Protection
11. Technical Specifications
Mains voltage
V 230
a 1
Frequency
Hz 50
Rated output
W 1000
Rated current
A 4.4
Fuse protection min. (time-lag or L-type circuit breaker)
A
10
Running capacitor
PF 12.5
Rated speed
min
-1
2800
Pump capacity max.
l/h
7500
Delivery head max.
m 36
Delivery pressure max.
bar
3.6
Immersion depth max.
m
10
Standing water max.
mm
30
Temperature of the primed medium max.
°C
35
Degree of protection
IP 68
Protection class
I
Insulation class
B
Materials
Pump casing
Pump shaft
Impeller
Polypropylene
Stainless steel
Noryl
Power cable (HO 7 RN-F)
m
15
Discharge port (AG=male, IG=female)
1" IG
Dimensions (pump casing)
Height
Diameter
mm
mm
470
150
Weight
kg 8.2
Max. length of extension cable
at 3 x 1.0 mm
2
lead cross-section
at 3 x 1,5 mm
2
lead cross-section
m
m
30
50