Memorex MT2025D - Manual (Page 18)

17
SETTING THE MENUS (CONTINUED)
This unit is equipped with a channel memory feature which allows channels to skip up or down to the next channels set into
memory, skipping over unwanted channels. Before selecting channels, they must be programmed into the unit’s memory.
FAQs:
How many channels will I actually receive?
The actual number of channels that can be received depends on how many channels your cable or satellite company, or
local area, provides. Contact your company to determine the number of channels in your area.
With the TV on, press the MENU button 1; the Video menu
will appear. Press the VOLUME Up button 2 to select the
Channel menu.
010 1
SKIP OFF
RECEPTION AIR
AUTO SCAN
COLOR SYSTEM
NTSC
CHANNEL
1
MUTE
Q.VIEW INFO
INPUT TV/DTV
SAP P.MODE
-
MENU
CH-
CH+
VOL - VOL +
CC SLEEP
GUIDE
FAV.LIST
ARC CH.LIST
EXIT
0
2
1
ENTER
Press the CHANNEL Up 1 or Down 2 button until
RECEPTION is selected. Press the VOLUME Up 3 or Down
4
button to select your option: AIR or CABLE. Press the
CHANNEL Up 1 or Down 2 button until AUTO SCAN is
selected.
MUTE
Q.VIEW INFO
INPUT TV/DTV
SAP P.MODE
-
MENU
CH-
CH+
VOL
-
VOL
+
CC SLEEP
GUIDE
FAV.LIST
ARC CH.LIST
EXIT
0
3
1
2
4
ENTER
2
Press the VOLUME Up button to start Auto Scan and the
unit will automatically cycle through all the channels (in
both NTSC and ATSC) and store active channels into
memory. When Auto Scan is complete, the lowest
memorized channel (NTSC/ATSC) will be displayed.
MUTE
Q.VIEW INFO
INPUT TV/DTV
SAP P.MODE
-
MENU
CH-
CH+
VOL
-
VOL
+
CC SLEEP
GUIDE
FAV.LIST
ARC CH.LIST
EXIT
0
ENTER
3
To stop Auto Scan before it is finished, press the MENU
button; the lowest memorized channel (NTSC/ATSC) will
be displayed.
MUTE
Q.VIEW INFO
INPUT TV/DTV
SAP P.MODE
-
MENU
CH-
CH+
VOL
-
VOL
+
CC SLEEP
GUIDE
FAV.LIST
ARC CH.LIST
EXIT
0
ENTER
4
SETTING CHANNELS INTO MEMORY
NOTE:
• Make sure that the antenna or cable is connected properly before plugging in the AC power cord, turning on the unit
and accessing the Channel menu.
• The Channel system must be set before setting the channels into memory (see the previous page).