MITSUBISHI ELECTRIC PKA-AGAL - Manual (Page 11)

11
AFTER
TIMER
OFF
AUTO OFF
∞
¡
¢ Timer Setting
1. Be sure that the “Auto Off” is visible on the screen (at ¡).
2. Hold down the Timer Menu button w for 3 seconds, so that “Monitor” is
indicated on the screen (at ¢).
• The timer remaining to shutdown appears at ∞.
3. To close the monitor and return to the standard control screen, press the
Mode (Return) button 2.
● Hold down the Timer On/Off button 9 for 3 seconds, so that “Timer Off”
appears (at §) and the timer value (at ¶) disappears.
● Alternatively, turn off the air conditioner itself. The timer value (at ¶) will
disappear from the screen.
˚F
˚F
AUTO OFF
§
¶
AUTO OFF
¶
˚F
˚F
AFTER OFF
AUTO OFF
§
¶
● Hold down the Timer On/Off button 9 for 3 seconds. The “Timer Off”
indication disappears (at §), and the timer setting comes on the display
(at ¶).
● Alternatively, turn on the air conditioner. The timer value will appear at ¶.
A
13
2
6.2. For wireless remote controller
1 Press the AUTO STOP or AUTO START button (TIMER SET).
• Time can be set while the following symbol is blinking.
OFF timer: A is blinking.
ON timer: A is blinking.
2 Use the
h
and
min
buttons to set the desired time.
3 Canceling the timer.
To cancel the OFF timer, press the
AUTO STOP
button.
To cancel the ON timer, press the AUTO START button.
• It is possible to combine both OFF and ON timers.
• Pressing the 1 ON/OFF button of the remote controller during timer
mode to stop the unit will cancel the timers.
• If the current time has not been set, the timer operation cannot be used.
7. Other Functions
˚F
˚F
TIME SUN
FUNCTION
PAR-21MAA
ON/OFF
FILTER
CHECK
OPERATION CLEAR
TEST
TEMP.
MENU
BACK DAY MONITOR/SET
CLOCK
ON/OFF
4
1
¡
Lock Indicator
7.1. Locking the Remote Controller Buttons (Operation
function limit controller)
■ If you wish, you can lock the remote controller buttons. You can use the
Function Selection of remote controller to select which type of lock to use.
(For information about selecting the lock type, see section 8, item [4]–2
(1)).
Specifically, you can use either of the following two lock types.
1 Lock All Buttons:
Locks all of the buttons on the remote controller.
2 Lock All Except ON/OFF:
Locks all buttons other than the ON/OFF button.
Note:
The “Locked” indicator appears on the screen to indicate that buttons are cur-
rently locked.
1. While holding down the Filter button 4, press and hold down the ON/OFF
button 1 for 2 seconds. The “Locked” indication appears on the screen
(at ¡), indicating that the lock is now engaged.
* If locking has been disabled in Function Selection of remote controller,
the screen will display the “Not Available” message when you press the
buttons as described above.
• If you press a locked button, the “Locked” indication (at ¡) will blink on
the display.
˚F
˚F
FUNCTION
¡
˚F
˚F
FUNCTION
¡
˚F
˚F
¡
1. While holding down the Filter button 4, press and hold down the ON/
OFF button 1 for 2 seconds—so that the “Locked” indication disappears
from the screen (at ¡).
6. Timer
BG79U794H02_en 05.12.22, 2:02 PM 11