Multiquip Portable Generator (Honda GX160 Gasoline Engine) GAC2.2H - Manual (Page 21)

gac2.2H 60 Hz geNeRaTOR • OpeRaTiON aNd paRTs maNual — Rev. #1 (03/31/10) — page 21
OperatiOn
This section is intended to assist the operator with the initial
start-up of the portable generator. It is extremely important
that this section be read carefully before attempting to use
the generators in the field.
Before starting the engine
1. Be sure to disconnect all electrical loads from the
generator prior to starting the engine.
2. NeveR start the engine with the main circuit breaker
in the ON position. Always place this circuit breaker
(Figure 9) in the OFF position before starting.
Figure 9. Main Circuit Breaker (OFF)
starting the engine
1. Place the engine fuel valve lever (Figure 10) to the ON
position.
Figure 10. Engine Fuel Valve Lever (ON)
2. Place the choke lever (Figure 11) in the clOsed
position if starting a cold engine.
Figure 11. Choke Lever
3. Place the choke lever (Figure 11) in the OpeN position
if starting a warm engine or the temperature is warm.
4. Place the engine ON/OFF switch (Figure 12) in the
ON position.
Figure 12. Engine ON/OFF Switch (ON)
5. Grasp the starter grip (Figure 13) and slowly pull it out.
The resistance becomes the hardest at a certain
position, corresponding to the compression point. Pull
the starter grip briskly and smoothly for starting.
Figure 13. Starter Grip
6. If the engine has started, slowly return the choke lever
(Figure 11) to the OpeN position. If the engine has not
started repeat steps 1 through 5.
7. Before the generator is placed into operation, run the
engine for 3-5 minutes. Check for abnormal smells,
fuel leaks, and noises that would associate with lose
components.
NOTICE
dO NOT pull the starter rope all the way to the end.
dO NOT release the starter rope after pulling. Allow it
to rewind as soon as possible.