For your safety read before lighting – Monessen Hearth VFCS20DNV User Manual

Page 21

58D6002

Figure 20 - Location of Piezo Ignitor, Control Knobs and Switch on Millivolt Unit

A. This appliance is equipped with an ignition device which automatically lights the pilot. If the piezo

is not working properly, see Match Lighting Instructions,

page 24.

B. BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the

floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS:

• Do not attempt to light any appliance.

• Do not touch any electric switch; do not use any phone in your building.

• Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instruc-

tions.

• If you cannot reach your gas supplier, call the fire department.

C. Use only your hand to push in, or turn the gas control knob. Never use tools. If the knob will not

push in or turn by hand, don't try to repair it. Call a qualified service technician. Force or attempted
repair may result in a fire or explosion.

D. Do not use this appliance if any part of it has been under water. Immediately call a qualified ser-

vice technician to inspect the appliance and to replace any part of the control system and any

OPERATING INSTRUCTIONS

FOR YOUR SAFETY READ BEFORE LIGHTING

Optional

Fan

Off/Pilot/On Knob

Hi/Lo Knob

Data and Instruction

Plates Located on

Back of Burner

Optional

Remote

Receiver

ARNING

If you do not follow these instruction
exactly, a fire or explosion may result
causing property damage, personal
injury or loss of life.