Mountain Buggy Buggy Range Outside Cove - Manual (Page 7)

5
ENGLISH
1
2
3
Safety Harness
To fasten
1. Clip shoulder straps to
waist strap buckles.
2. Push both waist buckle
ends into crotch strap.
To adjust
1. Adjust sliding buckles
so harness straps fi t
fi rmly.
Shoulder Strap Height
Shoulder strap height should be located just below
or level with a child’s shoulders. The older the child,
the further up the seat the straps need to be.
To adjust:
1. Locate buckle by slipping hand up the inside
back of the seat.
2. Push the rectangular shaped buckle through
the insertion slot on an angle, pushing the
corner of the buckle fi rst.
3. Re-thread the corner of the buckle through
the most suitable height insertion slot for your
child.
4. Once the buckle is through the slot, twist it so
it is fl at against the seat back and then check it
is secure by pulling on strap.
NB: a separate safety harness conforming to British
Standard BS6684 may be attached to the two
‘D’ rings located at the insertion of the waist
harness.
NB: Make sure baby
is positioned
down as far
as possible in
seat.