Mountain Buggy Buggy Range Outside Cove - Manual (Page 11)

9
ENGLISH
This vehicle requires regular maintenance by the user.
Cleaning
Fabric: The outdoor fabric should be cleaned regularly. Brush off any excessive
dirt or sand and rinse with lukewarm water. Fabric can be removed and
washed by hand using a mild natural soap solution in lukewarm water
(no more than 38°C/100°F). Rinse thoroughly. DO NOT tumble dry or dry
in strong sunlight.
Frame: If the buggy is used in exposed environments such as salt water, salt spray
or beach sand, wash any steel parts of the stroller by hosing the stroller or
use warm soapy water, dry thoroughly and protect by spraying with light
aerosol can oil, eg WD40® or CRC®.
NB: To avoid fabric fading, cover the stroller if it is exposed to direct sunlight through glass,
eg in a car or if stored in exposed areas.
Fabric may fade due to intense exposure to direct sunlight.
Fabric may develop mould or mildew if stored in humid or damp conditions.
Storage
Store stroller inside in a dry place but away from central heating units/radiators and do
not store in airing or hotwater cupboards.
Wheel Alignment (Terrain only)
It may be necessary to periodically adjust wheel alignment if the stroller steers to one side.
1.
Loosen all four nuts holding
struts in position.
2. Slightly tighten outside nut
on the opposite side to the
direction it is pulling (eg if it’s
steering to left tighten nut D).
3. Test the stroller by pushing it on
a smooth fl at surface.
4. When the correct steering is achieved, turn the outside nut on the opposite side
so it just touches the side of the tube.
5. Tighten the inside nuts.
Tyres/Tires
1. If a puncture occurs the inner tube can be repaired with a bicycle repair kit, or
replaced. If tread becomes worn the tyre should be replaced. Contact your local
dealer, or most cycle stores have tubes and repair kits.
2. Infl ate tyres to pressure of 20psi (140KPa). Do not exceed 30psi (210KPa).
A
B
D
C
Buggy Care