Metra Electronics 99-7013 - Manual (Page 8)

99-7013 KIT ASSEMBLY
6
B
C
DOUBLE DIN/STACKED ISO UNITS PROVISION
Cut and remove the center bar from
the Radio Housing. (Figure A) 1
Snap the Double DIN Brackets to the
inside edge of the Radio Housing.
(Figure B) 2
Slide the Double DIN or stacked ISO
unit(s) into the bracket/radio housing
assembly and secure the Double DIN
or stacked ISO unit(s) to the assembly
using the screws supplied with the
unit(s). (Figure C) 3
Snap the Double DIN Trim Plate onto
the front of the Radio Housing.
(Figure C) 4
Continue to final assembly.
* Note: Refer also to the instructions included with the aftermarket radio.
A