Use of the remote control with other a/v products – MITSUBISHI ELECTRIC LT-3050 User Manual

Page 27

If you cannot turn the cable box ON by pressing

POWER, try pressing CHANNEL or the number

buttons.

When set to TV, the PLAY, STOP, REW/REV, and

FF/FWD buttons will operate the VCR after the

VCR codes have been properly programmed into the

remote control.

Figure 3. Programming the remote to control your

VCR.

��

��
��
��
��
��
��
��
��
��

��
��
��
��
��
��
��
��

��
��
��
��
��
��
��
��
��

��

Figure 2. Programming the remote to control your

satellite receiver.

Figure 1. Programming the remote to control your
cable

box.

Use of the Remote Control with Other A/V Products

Programming the Remote Control

to Use with Other Brands of Audio

and Video Products:

(Figures 1-3 this page, figures 4-5 following page)

1. Move the slide switch at the top of the remote to

the product you want to control.

2. Press and hold the POWER button on the remote

control.

3. Enter the first three digit code listed for your

equipment, and then release the POWER button
on the remote control.

4. Point the remote control to the equipment and

press the POWER button.

Note: If the equipment responds, the remote control is

properly programmed to operate the equipment. If
the equipment does not respond, repeat steps 2-4
with the next three digit code listed in step 3 for

your equipment.

��

��
��
��
��
��
��
��
��

��
��
��
��
��
��
��

��
��
��
��
��
��
��
��
��

��

��
��
��
��
��
��
��
��

��
��
��
��
��
��
��

��
��
��
��
��
��
��
� ��
��

��

��
��

��