Multi-Tech Systems MT2834MR6 - Manual (Page 102)

102
Appendix
$MBn n = speed Modem Baud Rate
$MB75
Select ITU-T V.23 mode.
$MB300 Select 300 bps on line.
$MB1200 Select 1200 bps on line.
$MB2400 Select 2400 bps on line.
$MB4800 Select 4800 bps on line.
$MB7200 Select 7200 bps on line.
$MB9600 Select 9600 bps on line.
$MB12000 Select 12,000 bps on line.
$MB14400 Select 14,400 bps on line.
$MB16800 Select 16,800 bps on line.
$MB19200 Select 19,200 bps on line.
$MB28800 Select 28,800 bps on line.
*** $MB33600 Select 33,600 bps on line.
Nd d = 0 or 1 Dial a Stored Number
Dial stored telephone number
d .
NdNe... d = 0 or 1 Number Linking
e = 1 or 0 Dial stored number d ; if that is busy, dial stored number e . The command may be
extended N d N e N d N e ... to cycle between the two numbers.
O n/a Go Back On Line
Exit command mode and go into online mode after using the escape code to do the
reverse.
P In dialing *** Pulse-Dial
command Modem pulse-dials numbers that follow P.
&Pn n = 0 or 1 Set Pulse Dial Ratios
*** &P0 60:40 pulse ratio.
&P1 67:33 pulse ratio.
Note:The ZDXK is locked to &P1, a 67:33 ratio.
Q n n = 0–2 Result Codes Enable/Disable
*** Q0 Result codes sent.
Q1 Result codes suppressed (quiet).
Q2 No Response answer mode.
&Qn n = 0 or 1 Result Codes (Multi-Tech or Standard AT)
*** &Q0 Multi-Tech responses with modifiers.
&Q1 Standard AT responses with no modifiers.
Rn n = 0 or 1 Reverse Originate/Answer Mode
*** R0 Modem will not reverse modes.
R1 Modem will reverse modes when R is added to dial string.
&Rn n = 0, 1, or 2 Clear to Send Control
&R0
Let CTS state follow RTS state when online.
*** &R1 Force CTS high (on).
&R2 Let CTS drop on disconnect for time set by S24, then go high again.
&RAn n = 0 or 1 Asymmetric Bit Rate
*** &RA0 Enable asymmetric bit rate operation.
&RA1 Disable asymmetric bit rate operation.
&RDn n = 0 or 1 Square Wave Ring Detect
&RD0 Full wave ring detect only.
*** &RD1 Full wave and square wave ring detect.