beautypg.com

Troubleshooting, General, Additional information 13 – Pioneer XV-DV323 User Manual

Page 64

background image

Additional information

13

64

En

Troubleshooting

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble may lie in
another component. Investigate the other components and electrical appliances being used. If the
trouble cannot be rectified even after exercising the checks listed below, ask your nearest Pioneer
authorized service center or your dealer to carry out repair work.

Important

• If the system does not operate normally due to external effects such as static electricity

disconnect the power plug from the outlet and insert again to return to normal operating
conditions.

General

Problem

Remedy

The power does not
turn on.

• Connect the power plug to the wall outlet.
• Disconnect the power plug from the outlet, and insert again.
• Make sure there are no loose strands of speaker wire touching the rear
panel. This could cause the system to shut off automatically.

No sound is output
when a function is
selected.

• If you’re using the line input, make sure the component is connected
correctly (see

Connecting auxiliary components

on page 53).

• Press

MUTE

on the remote control to turn muting off.

• Adjust the

VOLUME

.

• If you’re using the TV input, make sure you’ve selected the RCA audio input
(see

Switching the TV audio input from SCART to RCA

on page 57).

No image is output
when playing discs.

• Make sure the TV is connected correctly (refer to the Setup Guide).

Not applicable to the European model –

Reset the video output to interlace

(see

Video Output settings

on page 49).

No sound from
surround or center
speakers.

• Refer to

Setting the channel levels

on page 46 to check the speaker levels.

• Check that you haven’t selected the

STEREO

sound mode (see

Listening in

surround sound

on page 24).

• Connect the speakers properly (refer to the Setup Guide).

Can’t operate the
remote control.

• Replace the batteries (refer to the Setup Guide).
• Operate within 7 m, 30° of the remote sensor on the front panel (refer to the
Setup Guide).
• Remove any obstacles or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
• You won’t be able to use the remote sensor of this unit with the

CONTROL

IN

jack of this unit connected to the

CONTROL OUT

jack of your plasma

display. You can use the remote sensor of the plasma display (even in
standby) as long as the power isn’t switched off.

XV-DV323.book 64 ページ 2004年1月13日 火曜日 午後7時57分

This manual is related to the following products: