Pioneer XV-DV323 - Manual (Page 47)

Surround sound and other settings 09
47
En
English
Français
Deutsch
Nederlands
Italiano
Español
3 Use the MASTER VOLUME +/– button to
adjust the volume to an appropriate level.
Turn down the volume to 40 or less to ensure
you have adequate headroom.
4 Use the / (cursor up/down) buttons
to adjust the speaker levels in turn.
You should hear the test tone at the same
volume from each speaker when seated in the
main listening position. The channel level
range is ± 10 dB.
5 When you’re done, press ENTER to exit
test tone setup.
Tip
• The speaker volume can be adjusted while
listening to any sound source you want by
pressing
CH LEVEL and then using the /
(cursor up/down) buttons to adjust the
channel levels. After you’re finished with
one channel, use the
/ (cursor left/
right) buttons to move to the next.
Note
• When the Auto listening mode is selected,
using the test tone method will adjust
levels for multichannel sources only. Use
CH LEVEL and the / (cursor up/down)
buttons (see tip above) to set levels for the
Auto listening mode with two channel
sources.
• Since the subwoofer produces ultra-low
frequencies its sound may seem quieter
than it actually is.
Setting_up_for_surround.fm 47 ページ ２００４年１月１５日 木曜日 午後５時１１分