Marantz PMD570 User Manual
Page 13
- 13 -
a
b
EDIT
MARK
M. RESET
REC BAL
MARK
DISPLAY
SHIFT
HEADPHONE
LEVEL
POWER ON/OFF
MENU/STORE
UNDO
SOLID STATE RECORDER PMD570
CANCEL
PUSH
ENTER
REC LEVEL/SELECT
MARK
TRACK
TOTAL TRACKTIME
REC REMAIN kbps
A-B
L
R
-dB
PM
kHz
AM
LINE
S.SKIP
-dB
over
0
2
6
1
2
20
40
00
0
10
LOCK
4
5
d
c
EDIT
MARK
M. RESET
REC BAL
MARK
DISPLAY
SHIFT
HEADPHONE
LEVEL
POWER ON/OFF
MENU/STORE
UNDO
SOLID STATE RECORDER PMD570
CANCEL
PUSH
ENTER
REC LEVEL/SELECT
MARK
TRACK
TOTAL TRACKTIME
REC REMAIN kbps
A-B
L
R
-dB
PM
kHz
AM
LINE
S.SKIP
-dB
over
0
2
6
1
2
20
40
00
0
10
LOCK
Controls and Connections
Front continued
4. CF card access light (green)
Flashing while the CF card is being read from or
written to.
Lit and steady while the CF card is ready.
5. CF card compartment
Pull to open to access the CF
card
Door Open is displayed.
Card eject
button
CF card slot
CF card door
Card eject button
The Card eject button has two positions: click out (a)
and click in (b).
To eject a CF card:
1. If recording or in playback push STOP .
If other operations are in progress cancel them by
pushing STOP or wait for them to complete.
2. Open the CF card door.
3. Push and release the Card eject button so it is in
click out position (a).
4. To eject the card, push the Card eject button from
the click out position to the click in position (b).
To insert a CF card:
1. Leave or push and release the Card eject button so
it is in the click in position (b).
CAUTION
If recording is in progress, opening the CF card
door automatically stops recording and writes
critical track information to properly close the file.
2. Fully insert the CF
card.
3. Close the CF card
door.
Note: If the CF card
door won't latch, check
that the Card eject button is in the click in position (b).
CF card security
(3mm x
10mm long)
The supplied CF card compartment
security screw requires using a
small Phillips screwdriver to open
the CF card compartment door.
That reduces the possibility that the
CF card will be misplaced or stolen.
1. Remove the plastic
pin (c) and then the
retainer (d).
2. Add the screw. Tighten the screw with a small
Phillips screwdriver tight enough so the screw
cannot be removed with a fingernail.