MGE UPS Systems 66074 - Manual (Page 62)

www.mgeups.com
Network
Management Cards
User Manual
T H E U N I N T E R R U P T I B L E P O W E R P R O V I D E R
Network Management Card – User Manual 34003676EN/GA Page 62/69
7 Maintenance
7.1 Software upgrade
7.1.1 Card firmware upgrade using Mupgrade (Windows)
This feature is particularly useful to upgrade a large UPS installed base in one operation.
Read the relevant documentation available for download on the www.mgeups.com web site, in the “ Download
area – embedded Software ” section.
7.1.2 Card software upgrade via TFTP (UNIX and Windows)
Upgrading is also possible with TFTP command.
Generic command is:
tftp -i @IP put nmc_fb.bin
upgrade@password@username
Where:
-i indicates binary mode
@IP is the address of the NMC card
nmc_fb.bin is the firmware name
@password value defined in the acces control page
@username value defined in the acces control page
Check syntax depending of your operating system
7.1.3 Recovery tool software via the serial link
Read the relevant documentation available for download on the www.mgeups.com web site, in the “ Download
area – embedded Software ” section.