Philips Magnavox MC194EMG - Manual (Page 8)

8 Setting TV Channels for the First Time
The TV/VCR can memorize the channels you receive in your
area. If you are using a Cable Box or Satellite Receiver, you
do not need to set channels at the TV/VCR. Set the TV/VCR
to the output channel of the Cable Box or Satellite Receiver
(channel 03 or 04). Then select the channel to be viewed on
the Cable Box or Satellite Receiver.
If you do not see these menus when you turn on the
TV/VCR for the very first time, set TV channels as instruct-
ed on page 14 instead.
1 Press POWER to turn on the TV/VCR.
2 Press F.FWD/B or REW/s to select ENG-
LISH or ESPAÑOL (Spanish). The selected lan-
guage will appear inside the [ ].
• The TV/VCR distinguishes
between standard TV channels
and Cable TV channels.
• To play or record a videotape
before setting TV channels, press
the MENU button to remove the
SETUP menu. To set up chan-
nels later, see Resetting TV
Channels on page 14.
• To select Cable TV channels
higher than 99, press the +100
button, then press the Number
buttons for the last two digits.
For example, to select channel
125, press +100, 2, 5. Precede
single-digit channel numbers with
a zero (for example, 01 ... 09).
• You will need to set up the lan-
guage and channels again after
a power failure.
Helpful Hints
3 Press PLAY/▲ or STOP/▼ to select AUTO
PRESET. Then press F.FWD/B. The TV/VCR
scans and memorizes all active channels in your area.
(To stop the scanning, press POWER to turn the
TV/VCR off, then on again.)
When scanning is complete, the TV/VCR will go to
the lowest available channel automatically.
Use the CH(annel) o/p button to select memorized
channels. Use the Number buttons to select non-
memorized channels.
TIME SEARCH MUTE RECORD
SPEED RESET
0
8 9 7
5 6 4
2 3 1
PAUSE/STILL
+100
STOP
F.FWD
PLAY
REW
VOL.
DISPLAY
MENU
POWER SLEEP/WAKE UP
CH.
ALT.CH
SLOW
1
2-3
– SET UP –
B LANGUAGE
[ENGLISH]
ESPAÑOL
AUTO PRESET
– SET UP –
LANGUAGE
[ENGLISH]
ESPAÑOL
B AUTO PRESET