Philips Magnavox MC194EMG - Manual (Page 6)

6 Hooking Up the TV/VCR
ANT.
ANT.
ANT.
ANT.
IN OUT
Connect an RF coaxial cable
(75-ohm, not supplied) to the
OUT Jack on the Cable
Box/Satellite Receiver and to the
ANT(enna) Jack on the TV/VCR.
Connect a Cable TV signal or an
antenna to the ANT(enna) Jack.
1 Hook up your TV/VCR using one of the connections shown.
ANT.
ANT.
Rod Antenna
(not supplied)
Connect the Cable TV/Satellite signal to the
IN Jack on the Cable Box/Satellite Receiver.
RF coaxial cable
(not supplied)
A Hooking Up Your
TV/VCR With a Cable
TV Signal or Outdoor
Antenna
B Hooking Up Your
TV/VCR With a Cable
Box/Satellite Receiver
To view any channel, set the
TV/VCR to the Cable
Box/Satellite Receiver output
channel (channel 03 or 04).
Then, select channels at the
Cable Box/Satellite Receiver.
C Hooking Up Your
TV/VCR With an
Indoor Antenna
To install a rod antenna (not
supplied), push the stem of
the antenna into the antenna
hole at the top on the rear of
the TV/VCR. Connect the
antenna wire to the
ANT(enna) Jack on the rear
of the TV/VCR as shown.
Extend the antenna and adjust
its length, direction, and angle
for the clearest picture.
Instructions continue on
the next page.