Connectors – MSI FUZZY CX700D User Manual
Page 25
2-7
Hardware Setup
Connectors
IDE Connector: IDEB1
The mainboard has a 32-bit Enhanced PCI IDE and Ultra DMA 33/66/100/133 controller
that provides PIO mode 0~4, Bus Master, and Ultra DMA 33/66/100/133 function. You
can connect hard disk drives, CD-ROM and other IDE devices.
The Ultra ATA133 interface boosts data transfer rates between the computer and the
hard drive up to 133 megabytes (MB) per second.
CompactFlash Card Slot: CF1
This CompactFlash slot shares one channel of the IDE controller. You can install one
CompactFlash typeI / type II device.
CF1
Important
* The CF1 slot and the IDEB1 connector shares and uses the same channel.
CF1 and IDEB1 can support up to 2 IDE devices without CF device or 1 IDE
device with 1 CF device.
* If you install two IDE devices, you must configure the second drive to Slave
mode by setting its jumper. Refer to the hard disk documentation supplied by
hard disk vendors for jumper setting instructions.
* If you install one IDE device with ATA133 IDE cable and one CF device, you
must configure the CF drive to Master mode by setting jumper JCF_SEL1. CF
only supports Master mode by using the ATA133 IDE cable.
* CF only supports Slave mode by using ATA33 IDE cable.
CF Mode Selecting Jumper:
JCF_SEL1
This jumper is used to select Master/
Slave mode of the CF device.
IDEB1
Slave
1
3
Master
1
3
1
JCF_SEL1
PDF created with pdfFactory Pro trial versi