beautypg.com

Troubleshooting before calling for service – MITSUBISHI ELECTRIC DIS710E User Manual

Page 22

background image

22

9. TROUBLESHOOTING

BEFORE CALLING FOR SERVICE

Use the following troubleshooting chart to resolve any apparent defect in operation. If you are
unable to resolve the problem, unplug the power cord and contact your dealer.

No power

• Is the power cord plug disconnected from the outlet?

Connect the power cord plug to the outlet firmly.

• Are the camera, printer and connection box turned on?

Confirm that they are turned on.

No signal

• Is the cable connected correctly?

Check each connection.

Image is not printed.

• Is the image data sent to the printer?

Confirm that the image data is sent to the printer.

• Is the print paper or ink sheet used up?

Check the status.

• Is the printing unit of the printer set correctly?

Set the printing unit correctly.

The camera setting does not work.

• Is the lock switch of the camera is set to OFF?

Check the lock switch is set to OFF.

The captured image is not focused.

• Is the focus mode set to “FOCUS LOCK”?

If the mode is set to “AUTO FOCUS”, change to

“FOCUS LOCK”.

Mechanical initialization

Causes

Countermeasures

2

2

2

2

2

THE RATIO OF FACE SIZES

The following chart shows the ratio of the face sizes between print image and LCD.

For example, if you wish to take the face size (on printed image) as 25mm, you would calculate
the face size based on the above chart.

E.g.

For 4-split, the ratio of printer and LCD is 1:1.77.
25mm (print size) x 1.77 (ratio) = about 44mm (on LCD)
So, you can mark a new circle on guide C.

See page 12 for guide sheet.

Type of multiple picture

Printer / LCD

1

1 : 0.87

2

1 : 1.33

4

1 : 1.77

6

1 : 1.35

16 1 : 3.50