MITSUBISHI ELECTRIC Mr.Slim MSY-A24NA - Manual (Page 12)

6
With the “ (I FEEL...)” auto operation mode, the optimum room condition can be set automatically
with a one-touch operation.
To start operation:
■
Press the
ON/OFF
button.
When the “ (I FEEL...)” mode is selected, the air conditioner is automatically
controlled at the optimum temperature.
To stop operation:
■
Press the
ON/OFF
button.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
If you feel slightly warm:
■
Press the
TOO WARM button to lower the temperature.
One press lowers the temperature by about 2°F.
If you feel slightly cool:
■
Press the
TOO COOL button to raise the temperature.
One press raises the temperature by about 2°F.
I FEEL... AUTO OPERATION
Details of operation
According to the room temperature when the operation starts, the operation mode is automatically set to COOL, DRY.
However, when operation is started again within 2 hours after it is stopped, the same operation mode before the operation
is stopped is selected. The operation mode selected first is not changed even if the room temperature changes. If the
operation mode does not match the room condition, select the appropriate operation mode by pressing the
MODE button.
Details of auto operation
Room temperature when started Operation mode Target temperature (initial state)
About 77°F or higher COOL About 75°F
About 77°F or lower DRY —
NOTE:
COOL: When the room temperature is 4°F higher than the set temperature, the set temperature may not be changed
since the air conditioner is operating to reach the target (set) temperature. In this case, please wait until
the room temperature drops to within 4°F of the set temperature and then change the set temperature.
Description of “I FEEL...” mode
When “ (I FEEL...)” is not selected, press the MODE button
until it is set.
Each time the button is pressed, the operation mode is changed
in sequence:
(I FEEL...) → (COOL) → (DRY) →
(FAN)
Description of “AUTO RESTART FUNCTION”
• These units are equipped with an auto restart function. When the main power is turned on, the air conditioner will start
operation automatically in the same mode as the one set with the remote controller before the shutoff of the main
power.
• If the unit was set to off with the remote controller before the shutoff of the main power, it will remain stopped even after
the main power is turned on.
• If the unit was in the emergency operation before the shutoff of the main power, it will start operation, when main power
comes on, in the same mode as the one set with the remote controller before the emergency operation.
• If the unit is operated in “I FEEL…” mode before power failure, the operation mode (COOL or DRY) is not stored in the
memory. When the main power is turned on, the unit decides the operation mode by the initial room temperature at
restart and starts operation again.