Metrologic Instruments MS9544 - Manual (Page 15)

11
H OW TO S CAN
Operator Note: PDF-CodeGate is disabled (by default) in all MS9544
Voyager PDF units.
1. The auto trigger activates the
laser when the bar code is
placed in the scanner's IR
range.
2. Position the laser line at the top
of the code then sweep the
beam over and down to the
base of the code. If needed,
re-sweep the entire code, up
and down. As segments of the
code are scanned, an audible
indicator will sound (default).
Operator Note:
Best scanning results are
accomplished with a
uniform sweep speed.
3. Once the entire code has been
scanned and decoded, the
data is transmitted to the host.
Transmission is accompanied
by the white LED flashing and
the beep sounding.
Figure 11.
Laser Beam
Sweep
Beam
Down
Figure 12.