Philips Magnavox MVR650MG/17 - Manual (Page 12)

12 Automatic Channel Setup
Although your VCR may set channels when you turn it on the first
time, you may set up channels again. Make sure:
● The VCR is on and is in VCR position. (The VCR/TV light will
appear on the display panel. If it does not, press VCR/TV once.)
● Your antenna or Cable TV signal is connected to the VCR. See
pages six-10.
1 Press MENU until MENU appears.
• Line Input mode is always channel
001 or 002. Select these channels
with the Number buttons or CH
. Choose L1 if you connect-
ed other equipment to the AUDIO
and VIDEO IN jacks on the back
of the VCR. Choose L2 if you con-
nected other equipment to the
AUDIO and VIDEO In jacks on
front of the VCR.
• You cannot program channels if
you are using a Cable
Box/Satellite. See pages eight-nine.
• To stop channel setup, press
CLEAR.
Helpful Hints
- M E N U -
TIMER PROGRAMMING
AUTO REPEAT
[OFF]
B CHANNEL SET UP
CLOCK SET
LANGUAGE SELECT
AUDIO OUT
TV STEREO
[ON]
SAP
- M E N U -
B TIMER PROGRAMMING
AUTO REPEAT
[OFF]
CHANNEL SET UP
CLOCK SET
LANGUAGE SELECT
AUDIO OUT
TV STEREO
[ON]
SAP
2 Press PLAY or STOP repeatedly to select CHANNEL
SET UP. Press F.FWD.
3 Press PLAY or STOP repeatedly to select AUTO SET
UP.
4 Press F.FWD. The VCR will memorize all available channels.
AUTO SET UP will flash and channels will count up as setup
progresses.When setup is complete, the lowest channel you
receive will appear on the TV screen.
MVR650MG/17 only
MVR650MG/17 only
CH
3 2 1
6 5 4
9 8 7
0
POWER
STATUS
SLOW REC MEMORY
SPEED SEARCH MODE STILL/PAUSE
VCR/TV EJECT
MENU CLEAR
REW
PLAY
STOP
F.FWD
1
2-4
CHANNEL SET UP
B AUTO SET UP
MANUAL SET UP