Motorola DCP 501 - Manual (Page 93)

O p e r a t i o n 8 3
DC P5 01 Us er Guide
B A L A N C E : L - 1 0
F A D E R : F - 1 4
Changing Balance and Fade on the DCP501
You can define the balance between left and right speakers, and between front and rear
speakers with the balance and fade settings. Balance and fade settings should only be used to
perform minor adjustments to the sound playback once the Speaker Test Tone Adjust has been
conducted. This must be performed while sitting at the listening position. Balance/fade
adjustments can reduce the maximum volume of the DCP501.
Balance and fade on the DCP501 are adjusted by attenuating the opposite set of channels. For
example, if you want the balance all the way to the right, the DCP501 and the on-screen display
show
B A L A N C E : L - 2 0 . Balance all the way to the left reads B A L A N C E : R - 2 0 . The factory
setting is 0 dB . The range for balance/fade is adjustable by up to 20 dB . To change the
balance/fade settings on the DCP501:
1 Press TONE / LEVEL three times to display B A L A N C E .
2 Press SELECT and the current setting flashes.
3 Press CURSOR left/right (
<<<< >>>>
) to set the balance between the left and right speakers and press
SELECT .
4 Press TONE / LEVEL four times to display F A D E R on your TV or F A D E on the DCP501
display.
5 Press SELECT and the current setting flashes.
6 Press CURSOR left/right (
<<<< >>>>
) to set the balance between the front and rear speakers and
press SELECT .
Below are examples of what is displayed on your TV when you adjust the balance/fade response
on your DCP501.
On-screen Display DCP501 Display
U s i n g t h e D C P 5 0 1 D V D / C D P l a y e r
This section describes your DCP501 DVD/CD player.
1 Press SOURCE to change to DVD/CD mode (Note: R E A D I N G is displayed on the DCP501
front panel). If no disc is present, the message N O D I S C is displayed.
2 Press the OPEN CLOSE on the front panel to open the loader and insert a disc.
3 Press OPEN CLOSE again to close the loader.
4 To begin playback, press PLAY PAUSE on the front panel, or the play button ( ►) on your
DCP501 remote control and the play icon ► is displayed.
5 To pause playback, press PLAY PAUSE on the front panel or on your DCP501 remote
control and the pause icon is displayed on the DCP501 front panel and P A U S E flashes
on your TV for a few seconds. Press PLAY PAUSE or right arrow play button( ►) to resume
playback.
F A D E F - 1 4
B A L L - 1 0